2 replies to this topic

[CallumAustin11]

Hi there,

I am in the process of completely replacing the entire floor along with toe board, boot floor and rear arches.
I have created a jig for this and just going through the measurements now to ensure everything is correct. I have measured from the front subframe tower bolt to the rear subframe boot floor mount (rear most hole) to be 2300mm exact.
Using pre existing dimensions I found on a drawing on another forum post. It says that measurement should be 2278mm. 20mm difference.

Should I be worried?

Many thanks

[gaspen]

Did you measure from-point-to-point or projected to the horizontal plane ?

 

If you want check symmetry it is a good idea to measure diagonals.

 

 22218510139cede138ce5a67f6e70f76b4ea4a76.jpg   35.73K   2 downloads

[CallumAustin11]

I measured level with the rear subframe mount