20 replies to this topic

[Matt29992]

I have for sale a 1.3 Nissan Micra engine with gearbox on approx 80,000 miles. It is mounted to a half done sub frame. 

 

Sale includes:

Engine and gearbox on part done sub frame

1.3 ECU and 1.0 ECU

Engine bay half of wiring loom

Both drive shafts

Gear selector

Micra radiator and fan

Inlet manifold, throttle body and fuel rail

Exhaust manifold

Starter motor

Micra water piping

Dihatsu Fourtrak alternator (small so fits on front of engine)

2 x Belt Tensioner from k series and a mondeo ST

CBR 600 carbs in good condition

EDIS from ford fiesta

Coil pack from fiesta

 

Looking for £300 for the lot. Need gone asap

Located near Leicester

 

http://s1081.photobu...ff9aaf.jpg.html

http://s1081.photobu...75a63c.jpg.html

http://s1081.photobu...4af729.jpg.html

http://s1081.photobu...b48850.jpg.html

http://s1081.photobu...bbcdfa.jpg.html

http://s1081.photobu...0095ab.jpg.html

http://s1081.photobu...53be2d.jpg.html

http://s1081.photobu...5a9d27.jpg.html

 

 

 

[olds_kool_lews]

Could well be interested in this! You open to a deal?

[Matt29992]

yes mate, let me know what you've got in mind

[kappa]

Do you still have this and are the driveshaft done to suit the mini hubs as well?

[Matt29992]

Still have this. Drive shafts are just standard micra. Now £250

[olds_kool_lews]

Whats the lowest you'd take?

[Matt29992]

Dont really want to drop below 250

[olds_kool_lews]

I'm VERY tempted, as been eyeing one up for my metro, let me see what my cash flow is like at the end of the month and If I can, I'll have it off u mate :)

[Matt29992]

Not a problem mate. In 10days ill be back in leicester (at uni at the moment). If you could let me know by then it would be great

[lukechallenger]

What's left to be completed on the subframe ?

[giacomo]

Tempting so tempting

[Matt29992]

What's left to be completed on the subframe ?

 

The frame is holding the engine using 3 land rover mounts. It needs welding properly as its mainly tacked at the moment. Space for drive shafts needs doing and suspension bits. Maybe some strengthening aspects put in but its pretty sturdy. Its a project and isnt just a drop in the car jobby

[Jordie]

Can u get some pictures?

[Matt29992]

I cant work out how tonput pictures up but the link I posted has a load of pictures

[Jordie]

Hard to see from pics....will this take a standard top arm, bottom arm and tie bar? Looks like the lower metal would prevent tie bar fitting.

 

Has it been tested in an engine bay for clearence etc?