450 replies to this topic

[hoody99]

I heard that but have also seen loads done this way lol when its welded ang ground and sealed you will never know lol

[SAL 821X]

Unless the MOT man reads TMF of course. ;)

[mark cottam]

Loos tidy....hope it all goes well!

[mark cottam]

*Looks

[hoody99]

Unless the MOT man reads TMF of course. ;)

He doesn't but does mot my daily lol he he

[hoody99]

Looks tidy....hope it all goes well!

Cheers bud

[hoody99]

More done







Not but my best welding but it was a bugger to do had to slice the Fitch to meet the a panel



Just the other side to do next lol

[grahama]

Done some slicing and re welding myself.  A panel and wing needed jiggling to fit together and as for the welding,  a good coat of stonechip will hide all that !

 

Keep it up pal,

 

Graham

[hoody99]

Woohoo more progress lol











font end welding nearly complete

cheers

[hoody99]

Well small progress today. Started to finish up the boot floor ready for arch tubbing. It now mounts the subby







both sides done. Tommorow I will finish this up and start to de bumper mount the rear. Not looking foreword to this but can only try. Filler will be my friend if all else fails lol. More soon

[hoody99]

Some more today





Looks so much better all one colour

Then made a start on the rear. Underseal is the devil took bloody ages but least the paint got time to dry lol





More next week hopefully

[hoody99]

Some more done today not perfect but its not a show winner lol











And a small purchase the other night



Cheers

Edited by hoody99, 14 June 2013 - 09:29 PM.

[JacckKirk]

Doin a similar project and was wondering what u used to strip the shell back to metal , also what was the floor like replacing as mine will be replaced soon also trying to get as many opinions as i can

[hoody99]

Well if it's just paint a soft wire wheel like the ones for drills but on a grinder but if it's under seal on the floor I used a heat gun with a small paint scraper then turps on a rag after that for the grubby bits also for old filler I use a knot wheel on the grinder. As for the floor it wasn't to bad first time I have done anything like this even the welding lol just don't rush and measure 6 times cut once lol found that out the hard way a few times. My best advice is look at lots of project on here and study how they have been done and if your stuck just ask

[JacckKirk]

Cheers