1693 replies to this topic

[minbin 69]

i might be wrong but i'd get the sill on first strenghthen it up before you move mate

[hoody99]

One side atta time bud finish one job before you start another or you will end up with half done bits everywhere like I did for awhile

[minimissions]

Yeah i agree with the above, looking good tho mate not long until subframes on....

[SAL 821X]

Righto cheers fella's just wasn't sure whether to leave the sills till I had the floor done and the heal board back on.

Edited by SAL 821X, 30 September 2013 - 11:07 AM.

[hoody99]

To be fair as long as both inner sills and door steps are there you can do the floor and heel board I would say

[SAL 821X]

Yes they are both in place hoody although I now need to do a half floor with inner sill on near side.

 

I wanted to get the drivers half floor finished, then do the passenger half floor with inner sill, then the heal board and finally the sills.

 

Just trying to make sure I do stuff in the right order.

[SAL 821X]

Got a spare hour or so tonight to go and do some more welding.

 

Also got some cash in my ebay account after selling a few bits so planning on getting the gravitex to paint the floor when it's done.

 

Would people advise getting the underbody coating gun like this one http://www.ebay.co.u...984.m1436.l2649 or can I stick it through the gravity gun with not many dramas?

[SAL 821X]

Just that little bit closer!

On the inside.


On the outside.


Started to lose the light though.

[Minidarren83]

Got a spare hour or so tonight to go and do some more welding.
 
Also got some cash in my ebay account after selling a few bits so planning on getting the gravitex to paint the floor when it's done.
 
Would people advise getting the underbody coating gun like this one http://www.ebay.co.u...984.m1436.l2649 or can I stick it through the gravity gun with not many dramas?

.

It will go through a gravity gun if you have a 2.5 mm nozzle and will leave a smooth finish just like a primer but thicker

Darren

[SAL 821X]

Hmmm.... Interesting thanks Darren, not sure what size the nozzle is on my gun but doubtful it's that big.

[SAL 821X]

Well thats the drivers side welded up.



One step closer just need to get it turned over now and do the same on the other side.

[Minidarren83]

Bet it feels good to have a solid floor good work mate

[hoody99]

This not done yet? Ha ha looking good buddy keep on cracking

[ryan22_lgm]

That floor looks much better!!! Good job getting rid of the nasty oversills ! :) we will have our mini van meet!

[minimissions]

bloody hell i need to get started lol

 

wicked work mate :)