530 replies to this topic

[minilee94]

Little update going to bleed the clutch and brakes finally today , fit my rad back in with new fan
Sorted the small oil leak I had out from timing cover
Ready to go to bill Richards racing on Saturday for it's final tune I can't wait


Tune moved to Sunday as bill has got a meeting

Edited by minilee94, 23 January 2015 - 09:27 AM.

[minilee94]

[minilee94]

[minilee94]

http://vid1103.photo...3C07A1C94C9.mp4

Do have a better video but can't put up as my dad was swearing in the video

But this is my mate have a little go in it

Edited by minilee94, 25 January 2015 - 09:20 PM.

[coopdog]

Haha I did see the vids on Instagram

[coopdog]

Also it sounds so good

[minilee94]

Cheers lol yeah had to swear in the video lol

[minilee94]

Finished

[minilee94]

Some nice big ram pipes fitted

[benjy_18]

How's the power graph look?

[The Matt]

How's the power graph look?

 

+1, post her up.  I built a very similar spec 1380 a few years ago and never got it rolling roaded.  It'd be good to see what the curves are like!

[minilee94]

I haven't had it rolling roaded yet either once bill is back from Monte Carlo it is going back to him for a proper geometry setup and another full tune

[minilee94]

Pretty torquey and it wasn't on cam

So will have to see

Bill and med both have estimated it at 120

[minilee94]

And matt in reply to the status the otherday 6k spent I'm not going to list it all as it's big spec but
£1000 on gearbox ,£350 pistons , block boring £150 new x drilled and nitrided crank with arp bolts £400 , cam kit £380 , flywheel and clutch kit £410, 3piece push rods cost me about £70 , rockers £170 , final drive £50 center strap + machining £60 , water pump £25
Dizzy £225 , coil £25 , head I got cheap all in with rebuild £200 , head bolts cost me £80 , new pot joints genuine £120 , carb set up £ 350 ,manifold £90 , new primary gear washer £35 , all new bearings in side casing , block machining £200 , thermex rad , £120 , oil cooler and hoses £80 , filter housing £50 , new manifold studs etc £20 , alternator £60 hi torque starter £160 engine and box gasket set £25 new clutch master , clutch slave , Braided hoses , brake cylinder + braided lines , med alloy crank damper pulley £160

might be more but can't think about em at the moment

[brad-the-bear]

what's your engine spec bud?