was just browsing minifinity when i found this...........
Lead connection order for an MPi coil pack as follows.
Looking at the coil pack from the front (thermostat end) of the engine. Cylinder 1 is nearest the water pump, cylinder 4 is at the flywheel end. The engine firing order is 1-3-4-2.
*
Bottom left on the coil pack goes to plug 1
*
Bottom right on the coil pack goes to plug 2
*
Top right on the coil pack goes to plug 3
*
Top left on the coil pack goes goes to plug 4
As the ignition on an MPi is a wasted spark system, you may find that it runs just as well with a pair of leads swapped over. The order above is the “correct” order though.
well iv bin and checked mine because i knew it was different iv got mine set the same as stated in my haynes manual which is
bottom left - plug 1
top left - plug 2
top right - plug 3
bottom right - plug 4
is this correct or not? i dont want to change them and find that it damages something
any ideas?????
ht lead setup
Started by
THedooBZ
, Jan 04 2006 11:15 PM
2 replies to this topic
#1
Posted 04 January 2006 - 11:15 PM
#2
Posted 04 January 2006 - 11:17 PM
i might not be right but the mpi uses a wasted spark system so wont make a difference as you get 2 sparks on the cycle :smartass:
#3
Posted 04 January 2006 - 11:30 PM
well its obviously not a prob even if i did have them wrong as theve been like it for months, just wanted to make sure,
cheers
cheers
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users