240 replies to this topic

[JonBetts]

i have a pick-up shell i can use to measure up here, will have another look at possible designs. can u measure where would be the ideal height in your car to match the seats u r using please

[E.L.M.O]

i have a pick-up shell i can use to measure up here, will have another look at possible designs. can u measure where would be the ideal height in your car to match the seats u r using please

cool, but i have a special requirement for where i want the bar to be in relation to my seats. ie just above them but below the head rests i have speedwell cubs

[JonBetts]

will need a measurement from the floor then and how far from the back of the cab

[E.L.M.O]

Seats will be right up against the rear bulk head, and id like the bar to go across just above them, so will get he meassurements once the seats are in

[megamini_jb]

Hi, would you be able to make one for a different car? Obvs I'll get measurements

Cheers

[megamini_jb]

Something similar to this

Edited by megamini_jb, 25 August 2012 - 03:37 PM.

[JonBetts]

Should be able to sort something, is that just mounting on the shock tops at the end hence the extra bracing points?

[JVR19630]

Hi Jon,
Looking for a wrap round the same as Toyboy396 but can't see them on your website
can you help. ?
Cheers John

[matty1303]

New designs

HI Jon

Would it be possible to get a harness bar like this one, with the loops please?

cheers Matt

Edited by matty1303, 13 September 2012 - 03:17 PM.

[SAL 821X]

Hi Jon,

Fantastic I'd been musing recently about having a harness bar for the Van and was going to try and make one with my limited fabrication skills this seems like a much easier method.

However I have one question regarding the design as I had a slightly different idea about mounting the bar. Would it be possible to mount the bar via the top mount of the suspension as the van obviously has accessible top mounts?

If not would your current mounting points be ok to use on a van.

I can see one being added to the Christmas list if so.

Cheers,

Matt

[SAL 821X]

Well I've just answered my own question by looking at your facebook page Jon...... hahaha!

http://www.facebook....&type=1

This is just what I'm after but with the screw in harness quick release mounts.

Cheers,

Matt

[JonBetts]

Thats only a strut brace and wouldnt be strong enough for a harness bar, I can fabricate one for a van no problem, email me on [email protected] Jon

[SAL 821X]

Thats only a strut brace and wouldnt be strong enough for a harness bar, I can fabricate one for a van no problem, email me on [email protected] Jon

Cheers Jon, I will drop you a email when I've asked Santa nicely.

[SAL 821X]

Hi Jon,

Got the go ahead from Santa.

Will drop you a email.

Matt

[JonBetts]

OK chap