I'm having problems getting a good seal around my tappet bolts. Initially I used the seals that came with my gasket set but these failed and split (maybe I over tightened them) so I pop to my local auto supply store and buy a pack of rubber sealing washers.
I use the most appropriate looking ones and even put a smidge of RTV round to help but I think it's leaking from here again!
Any tips on sorting this out?
Cheers
Joe
Leaky Tappet Bolt Seals
Started by
Pooky
, Jun 09 2009 10:41 AM
2 replies to this topic
#1
Posted 09 June 2009 - 10:41 AM
#2
Posted 09 June 2009 - 10:47 AM
They are tricky little *rat weasels* aren't they. The problem i found with mine is that in order to get the main cover tight enough not to leak i had to (chose to) over tighten the bolt - causing the same problem you have with the bolt seal.
As you say - a very thin bead of RTV might solve the problem - Personally i think you're just going to have to try it out and see what happens. Make sure no RTV seeps into the tappet chest when you tighten it up.
difficult!
As you say - a very thin bead of RTV might solve the problem - Personally i think you're just going to have to try it out and see what happens. Make sure no RTV seeps into the tappet chest when you tighten it up.
difficult!
#3
Posted 09 June 2009 - 07:28 PM
Any more tips for this peeps? Does anywhere do a tapered seal that fills the hole out?
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users