13 replies to this topic

[TR7]

hi all

were does the baulk head box need to go on the baulk head ie
top / middle / bottom / if i was to install a mg turbo

regards mark

[Turbo Nick]

[Ollie]

here's mine when it was put in.





still need to tidy up the welds. Will be able to do that now my front subframe has been removed

[Turbo Nick]

snap, my £6 grinder died after cutting the bulkhead so i couldn't linish mine afterwards, lol.

[Ollie]

haha, no one see''s it once then engine is there i spose. But it's one of those little things that would bug me if i didn't do it.

love your clubman it's ace!

[TR7]

does anything need to be done in side of car?

[Ollie]

just make sure your wiring loom isn't in the way lol. & to weld some new heater brackets on the back of the box

[madmatman24]

Are there any Exact measurements from the side to where the box start's?

cheer's matt

[Turbo Nick]

not really, i've always just put it pretty close to the master cylinder mounting plate.

[notthatrusty]

i found buds pics very usefull. even though i still managed to *male chicken* it up.lol

[dannyg2325]

sorry to kinda hijack!!

ive got my box welded in, does the heater move forward much after this? just thinkin bout my centre console! lol

dan

[adster]

about 2"

[dannyg2325]

about 2"

cheers adster!! ope it all fits together again! lol

[mini13]

can i sugest getting your bulkhead box's from a ebay seller called butterpoppy.

I have had one and they are really good, slightly deeper than normal ones with a sloped bottom to let any water run out. cheap too!